Cisco ASR1006 - ASR 1006 Modular Expansion Base User Manual

Configuring MPLS Layer 2 VPNs
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
11
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
pseudowire-class atm-fr-bridged
encapsulation mpls
interworking ethernet
!
interface Loopback0
ip address 44.1.1.2 255.255.255.255
!
interface GigabitEthernet0/0/1
ip address 10.10.1.2 255.255.255.0
negotiation auto
mpls ip
!
interface ATM0/1/2
no ip address
atm clock INTERNAL
no atm enable-ilmi-trap
!
interface ATM0/1/2.1 point-to-point
mtu 1500
no atm enable-ilmi-trap
pvc 10/100 l2transport
encapsulation aal5snap
xconnect 190.1.1.1 100 pw-class atm-fr-bridged
!
!
To configure the Frame Relay-to-ATM Bridged Interworking feature on a Frame Relay PE router,
perform the following steps:
Note The following configuration uses a channelized T1/E1 interface. Frame Relay can be configured on other
interfaces such as Packet over SONET (PoS) as well.
SUMMARY STEPS
1. enable
2. configure terminal
3. (Optional) ipv6 unicast-routing
4. mpls label protocol ldp
5. mpls ip default-route
6. mpls ldp graceful-restart
7. frame-relay switching
8. xconnect logging pseudowire status
9. controller t1 slot/subslot/port
10. framing esf
11. clock source internal
12. linecode b8zs
13. cablelength long db-loss-value
14. channel-group channel-group-number timeslots range
15. exit

Cisco ASR1006 - ASR 1006 Modular Expansion Base Specifications

General

Brand	Cisco
Model	ASR1006 - ASR 1006 Modular Expansion Base
Category	Network Router
Language	English