Cisco ASR1006 - ASR 1006 Modular Expansion Base User Manual

Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
24
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Any-to-EtherChannel over MPLS (Bridged) Interworking
You can configure Any-to-EtherChannel over MPLS (Bridged) interworking on the Cisco ASR 1000
Series Routers.
Any-to-EtherChannel over MPLS (Bridged) interworking supports the following modes:
• Frame Relay-to-EtherChannel
• ATM-to-EtherChannel
• Ethernet-to-EtherChannel
Irrespective of the mode used, in Any-to-EtherChannel over MPLS (Bridged) interworking, configure
L2V
PN interworking on the upstream interfaces of PE routers. For more information about configuring
L2VPN interworking on the PE routers, see L2VPN Interworking Modes, page 2.
For information about how to configure Frame Relay or
ATM on the downstream interfaces of a PE
router, see the Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking, page 6.
Meanwhile, perform the ste
ps described in the EtherChannel-to-EtherChannel over MPLS (Bridged)
Interworking, page 19, on the downstream interfaces of the other PE router.
For the Ethernet-to-EtherChannel mode, perform the steps described in Et
herChannel-to-EtherChannel
over MPLS (Bridged) Interworking, page 19 on the do
wnstream interfaces of the other PE router.
Meanwhile, perform the following steps on the do
wnstream interfaces of the PE routers.
SUMMARY STEPS
1. enable
2. configure terminal
3. mpls label protocol ldp
4. interface loopback loopback-interface-number
5. ip address ip-address ip-subnet-mask
6. exit
7. pseudowire-class pw-class-name
8. encapsulation mpls
9. interworking ethernet
10. interface GigabitEthernet slot | subslot | port
11. xconnect peer-ip-address vc-id encapsulation mpls pw-class pw-class-name

Cisco ASR1006 - ASR 1006 Modular Expansion Base Specifications

General

Brand	Cisco
Model	ASR1006 - ASR 1006 Modular Expansion Base
Category	Network Router
Language	English