Cisco ASR1006 - ASR 1006 Modular Expansion Base User Manual

Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
19
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Configuring Gigabit EtherChannel for Virtual Private Wire
Service
The GEC VPWS support feature is supported by AToM on the EtherChannel Interface, and includes the
following features:
• EtherChannel-to-EtherChannel over MPLS (Bridged) Interworking, page 19
• EtherChannel-to-EtherChannel over MPLS (Routed) Interworking, page 21
• Any-to-EtherChannel over MPLS (Bridged) Interworking, page 24
• Any-to-EtherChannel over MPLS (Routed) Interworking, page 26
EtherChannel-to-EtherChannel over MPLS (Bridged) Interworking
Configure L2VPN interworking on the upstream interfaces of the PE routers. For more information
about configuring L2VPN interworking on the PE routers, see L2VPN Interworking Modes, page 2.
After configuring MPLS Forwarding, perform the following steps on the downstream interfaces of the
PE routers.
SUMMARY STEPS
1. enable
2. configure terminal
3. mpls label protocol ldp
4. interface loopback loopback-interface-number
5. ip address ip-address ip-subnet-mask
6. exit
7. pseudowire-class pw-class-name
8. encapsulation mpls
9. interworking ethernet
10. exit
11. interface port-channel number
12. xconnect peer-ip-address vc-id encapsulation mpls pseudowire-class pw-class-name
13. interface GigabitEthernet slot | subslot | port
14. channel-group port-channel number

Cisco ASR1006 - ASR 1006 Modular Expansion Base Specifications

General

Rack Units	6U
Form Factor	Rack-mountable
Operating Temperature	32 to 104°F (0 to 40°C)
Product Type	Router
Slots	6
Redundancy	Redundant Power Supply Supported
Maximum Throughput	100 Gbps
Dimensions	17.5" Width
Weight	Approximately 130 lbs (59 kg)
Interfaces/Ports	Varies by installed modules
Memory	4 GB
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Relative Humidity	5% to 95% (noncondensing)
Compliance	CE, UL