Cisco ASR1006 - ASR 1006 Modular Expansion Base User Manual

Software Upgrade Process
ISSU Upgrade for Redundant Platforms
6
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
• Using ISSU to Perform a Consolidated Package Upgrade in a Dual Route Processor Configuration,
page 6
• Using ISSU to Upgrade the SubPackages in a Dual Route Processor Configuration, page 12
Using ISSU to Perform a Consolidated Package Upgrade in a Dual Route Processor Configuration
Consolidated packages can only be upgraded using ISSU in dual Route Processor configurations. ISSU
is not supported for consolidated package upgrades in single Route Processor configurations.
If you want the RPs on your Cisco ASR 1000 Series router to be running using a consolidated package
after t
he ISSU upgrade is complete, use the following instructions:
Note This procedure will only work if the current RPs are already running consolidated packages.
SUMMARY STEPS
1. ip tftp source-interface gigabitethernet slot/port
2. copy tftp: URL-to-target-location
3. copy source-file-system:filename standby-destination-filesystem
4. dir URL-to-target-location
dir U
RL-to-target-stby-location
5. issu loadversion rp upgrade-rp-number standby-file-system:filename
6. issu runversion
7. telnet ip-address port
8. issu acceptversion
9. issu commitversion
10. show version, show version active-RP running, show version active-RP provisioned
show platform
show running-configuration
11. hw-module slot RP slot number reload

Cisco ASR1006 - ASR 1006 Modular Expansion Base Specifications

General

Brand	Cisco
Model	ASR1006 - ASR 1006 Modular Expansion Base
Category	Network Router
Language	English