Software Upgrade Process
ISSU Upgrade for Redundant Platforms
7
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
DETAILED STEPS
Command or Action Purpose
Step 12
ip tftp source-interface gigabitethernet slot/port
Example:
Router(config)# ip tftp source-interface
gigabitethernet 0
Specifies the Gigabit Ethernet TFTP
source-interface to be configured:
slot/port—Specif
ies the location of the TFTP
source-interface.
Note To copy a file using TFTP through the
Management Ethernet interface, the ip tftp
source-interface GigabitEthernet 0
command must be entered before entering
the copy tftp command.
Step 13
copy tftp: URL-to-target-location
copy source-file-system:filename
standby-destination-filesystem
Example:
Router# copy tftp bootflash:
Copy the consolidated package onto the active RP.
Step 14
copy source-file-system:filename
standby-destination-filesystem
Example:
Router# copy
bootflash:asr1000rp1-adventerprisek9.02.01.01.122-33.
XNA1.bin stby-bootflash:
Copy the consolidated package onto the standby RP.
Step 15
dir URL-to-target-location
dir
URL-to-target-stby-location
Example:
Router# dir bootflash:
Router# dir
stby-bootflash:
(Optional) Display the contents of the target
directories to confirm the successful copy of the file
package.
Step 16
issu loadversion rp upgrade-rp-number
standby-file-system:filename
Example:
Router# issu loadversion rp 1 file
stby-bootflash:asr1000rp1-adventerprisek9.02.01.01.12
2-33.XNA1.bin
Load the target consolidated package onto the
standby RP.
After you receive the message indicating that the
t
erminal state has been reached, go on to Step 17.
To Next Page
Need help?
General
