Cisco ASR1006 - ASR 1006 Modular Expansion Base User Manual

Configuring MPLS Layer 2 VPNs
Feature Information for Configuring MPLS Layer 2 VPNs
32
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Ta b l e 2 Feature Information for Configuring MPLS Layer 2 VPNs
Feature Name Releases Feature Information
Frame Relay to ATM Bridged Interworking 3.6.0S The Frame Relay to ATM Bridged Interworking feature
pro
vides interoperability between the Frame Relay
attachment VC and the ATM attachment VC connected to
different PE routers. The bridged encapsulation
corresponding to the bridged (Ethernet) interworking
mechanism is used. The Ethernet frames are carried through
the MPLS network using Ethernet over MPLS (EoMPLS).
In Cisco IOS XE Release 3.6.0S, this feature was
imp
lemented on the ASR 1000 Series Aggregation Services
Routers.
The following sections provide information about this
feat
ure:
• Frame Relay DLCI-to-ATM AAL5SNAP Bridged
Interworking, page 4
• Configuring Frame Relay DLCI-to-ATM AAL5SNAP
Bridged Interworking, page 6
xconnect support on GEC (VPWS) on
ASR
1000
3.6.0S The Xconnect Support on GEC (VPWS) on ASR1000
feature enables the service providers to supply connectivity
between customer sites with existing data link layer (Layer
2) networks by using a single, integrated, packet-based
network infrastructure—a Cisco MPLS network. Instead of
separate networks with network management environments,
service providers can deliver Layer 2 connections over an
MPLS backbone.
In Cisco IOS XE Release 3.6.0S, this feature was
imp
lemented on the ASR 1000 Series Aggregation Services
Routers.
The following sections provide information about this
feat
ure:
• Gigabit EtherChannel for Virtual Private Wire Service,
page 17
• Configuring Gigabit EtherChannel for Virtual Private
Wire Service, page 19

Cisco ASR1006 - ASR 1006 Modular Expansion Base Specifications

General

Brand	Cisco
Model	ASR1006 - ASR 1006 Modular Expansion Base
Category	Network Router
Language	English