Cisco Catalyst 3650 Series Guide

1-12
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
Chapter 1 Product Overview
Front Panel
USB Console LED
The USB console LED (Figure 1-4) shows whether there is an active USB connection to the port.
ACTV LED
PoE+
1
Off PoE+ is off.
If the powered device is receiving power from an AC power source,
the port LED is off even if the device is connected to the switch port.
Green PoE+ is on. The port LED is green when the switch port is providing
power.
Alternating
green and
amber
PoE+ is denied because providing power to the powered device will
exceed the switch power capacity.
Blinking amber PoE+ is off due to a fault or because it has exceeded a limit set in
the switch software.
Caution PoE+ faults occur when noncompliant cabling or
powered devices are connected to a PoE+ port. Use only
standard-compliant cabling to connect Cisco prestandard
IP Phones and wireless access points or
IEEE 802.3af-compliant devices to PoE+ ports. You must
remove from the network any cable or device that causes
a PoE+ fault.
Amber PoE+ for the port has been disabled.
Note PoE+ is enabled by default.
1. Only switches with PoE or PoE+ ports.
Table 1-4 Meaning of Switch LED Colors in Different Modes (continued)
Port Mode Port LED Color Meaning
Table 1-5 USB Console Port LED
Color Description
Off USB console is disabled.
Green USB console is enabled.
Ta b l e 1- 6 A C T V L E D
Color Description
Off Switch is not the active switch.
Green Switch is the active switch or a standalone switch.

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English