1-27
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
How to Migrate to a Cisco CRS-3 Carrier Routing System (16-Slot)
<snip>
0/SM0/SP FC/S(SP) N/A UNPOWERED PWR,NSHUT,MON
0/SM1/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM2/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM3/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM4/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM5/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM6/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM7/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
<snip>
What to Do Next
Next we physically remove the CRS-1 fabric card.
Physically Removing the CRS-1 Fabric Card
This section describes how to physically remove the CRS-1 fabric card, and verify that node is ready to
have a CRS-3 fabric card installed in its place.
This section describes how to remove a switch fabric card (SFC) [in this case, the CRS-1 fabric card]
from the Cisco CRS Fabric Card Chassis. For more detailed information on the Cisco
CRS fabric cards,
see Cisco CRS Carrier Routing System 16-Slot Line Card Chassis System Description.
Caution Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 281
Warning
For diverging beams, viewing the laser output with certain optical instruments within a distance of
100 mm may pose an eye hazard. For collimated beams, viewing the laser output with certain optical
instruments designed for use at a distance may pose an eye hazard.
Statement 282
Warning
Laser radiation. Do not view directly with optical instruments. Class 1M laser product.
Statement 283
On the LCC chassis disconnect the Trimese cables on the SM cards associated with the planes that you
have shut down. If the cables are going to be disconnected for an extended period of time cap the ends
with dust covers.
To Next Page
Loading...
Need help?
General
