Cisco CRS-1 - Carrier Routing System Router Migration Guide

1-39
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
How to Migrate to a Cisco CRS-3 Carrier Routing System (16-Slot)
What to Do Next
When all chassis in the multishelf system are operational and communicating with each other, it is time
to continue system configuration, as described in the documents in the “Related Documents” section on
page
1-63.
Troubleshooting Tips
For troubleshooting information, see the documents described in the “Related Documents” section on
page
1-63.
Example
The following example shows commands to enable power to the newly installed CRS-3 Fabric Card:
RP/0/RP0/CPU0:router#admin
RP/0/RP0/CPU0:router(admin)#config
RP/0/RP0/CPU0:router(admin-config)#no hw-module power disable loc 0/SM0/SP
RP/0/RP0/CPU0:router(admin-config)#commit
Verify that power has been enabled to the Fabric Node (state is not UNPOWERED).
RP/0/RP0/CPU0:router(admin)#show platform
Node Type PLIM State Config State
<snip>
0/SM0/SP FC-140G/S(SP) N/A PRESENT PWR,NSHUT,MON
0/SM1/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM2/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM3/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM4/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM5/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM6/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
0/SM7/SP FC/S(SP) N/A IOS XR RUN PWR,NSHUT,MON
Step 11
no controllers fabric rack 1 install-mode
Example:
RP/0/RP1/CPU0:router(admin-config)# no
controllers fabric rack 1 install-mode
Modifies the target configuration to change the Rack 1
configuration to normal mode.
Step 12
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Commits the target configuration to the router running
configuration.
Step 13
do show controllers rack-status all detail
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers rack-status all detail
Displays the status of all racks in the system.
• In a properly operating system, the rack status for all
racks should be Normal, and the server status should be
Present.
Command or Action Purpose

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English