Cisco CRS-1 - Carrier Routing System Router Migration Guide

1-43
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
• The control network must be set up as described in the “Prerequisites for Upgrading to a
Cisco
CRS-3 Carrier Routing System” section on page 1-2.
• The single-chassis system that is being migrated does not have to be powered down.
Restrictions
None.
SUMMARY STEPS
1. admin
2. configure
3. hw-module power disable loc 0/SM0/SP
4. commit
5. end
6. Repeat Step 3 through Step 5 for each fabric plane.
7. show platform
DETAILED STEPS
Command or Action Purpose
Step 1
admin
Example:
RP/0/RP0/CPU0:router#admin
Places the router in administration EXEC mode.
• All commands listed in this procedure should be
entered on the pre-existing single-chassis system.
Step 2
configure
Example:
RP/0/RP1/CPU0:router(admin)#configure
Places the router in administration configuration mode.
Step 3
hw-module power disable loc 0/SM0/SP
Example:
RP/0/RP1/CPU0:router(admin-config)# hw-module
power disable loc 0/SM0/SP
Disables the power to the specified fabric plane in your
single-chassis system.
Step 4
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Commits the target configuration to the router running
configuration.
• This step brings up the previously shutdown plane,
which is now configured to use the FCC-CRS-3 fabric
card.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English