Cisco Firepower 1010 User Manual

View Hardware Information
Use the command-line interface (CLI) to view information about your hardware, including the device model,
hardware version, serial number, and chassis components including power supplies and network modules.
You can access the CLI by connecting to the console port; see Access the Threat Defense and FXOS CLI, on
page 111.
Procedure
Step 1 To display the hardware model of the device, use the show model command.
> show model
Example:
> show model
Cisco Firepower 1010 Threat Defense
Step 2 To display the chassis serial number, use the show serial-number command.
> show serial-number
Example:
> show serial-number
JMX1943408S
This information is also shown in show version system, show running-config, and show inventory output.
Step 3 To display information about all of the Cisco products installed in the networking device that are assigned a
product identifier (PID), version identifier (VID), and serial number (SN), use the show inventory command.
> show inventory
a) From the threat defense CLI:
Example:
> show inventory
Name: "module 0", DESCR: "Firepower 1010 Appliance, Desktop, 8 GE, 1 MGMT"
PID: FPR-1010 , VID: V00 , SN: JMX1943408S
b) From the FXOS CLI:
Example:
firepower /chassis # show inventory
Chassis PID Vendor Serial (SN) HW Revision
---------- --------------- ----------------- ----------- -----------
1 FPR-1010 Cisco Systems, In JMX1943408S 0.3
Cisco Firepower 1010 Getting Started Guide
113
Threat Defense Deployment with the Device Manager
View Hardware Information

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English