Cisco Firepower 1010 User Manual

To check the DDNS operation:
show ddns update interface fmc_access_ifc_name
> show ddns update interface outside
Dynamic DNS Update on outside:
Update Method Name Update Destination
RBD_DDNS not available
Last Update attempted on 04:11:58.083 UTC Thu Jun 11 2020
Status : Success
FQDN : domain.example.org
IP addresses : 209.165.200.225
Check CDO log files
See https://cisco.com/go/fmc-reg-error.
Roll Back the Configuration if CDO Loses Connectivity
If you use a data interface on the threat defense for manager access, and you deploy a configuration change
from CDO that affects the network connectivity, you can roll back the configuration on the threat defense to
the last-deployed configuration so you can restore management connectivity. You can then adjust the
configuration settings in CDO so that the network connectivity is maintained, and re-deploy. You can use the
rollback feature even if you do not lose connectivity; it is not limited to this troubleshooting situation.
See the following guidelines:
• Only the previous deployment is available locally on the threat defense; you cannot roll back to any
earlier deployments.
• The rollback only affects configurations that you can set in CDO. For example, the rollback does not
affect any local configuration related to the dedicated Management interface, which you can only configure
at the threat defense CLI. Note that if you changed data interface settings after the last CDO deployment
using the configure network management-data-interface command, and then you use the rollback
command, those settings will not be preserved; they will roll back to the last-deployed CDO settings.
• Out-of-band SCEP certificate data that was updated during the previous deployment cannot be rolled
back.
• During the rollback, connections will drop because the current configuration will be cleared.
Procedure
Step 1 At the threat defense CLI, roll back to the previous configuration.
configure policy rollback
After the rollback, the threat defense notifies CDO that the rollback was completed successfully. In CDO, the
deployment screen will show a banner stating that the configuration was rolled back.
Cisco Firepower 1010 Getting Started Guide
163
Threat Defense Deployment with CDO
Roll Back the Configuration if CDO Loses Connectivity

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English