Cisco Firepower 1010 User Manual

Firepower 1010 Default Configuration
The default factory configuration for the Firepower 1010 configures the following:
• Hardware switch—Ethernet 1/2 through 1/8 belong to VLAN 1
• inside→outside traffic flow—Ethernet 1/1 (outside), VLAN1 (inside)
• management—Management 1/1 (management), IP address 192.168.45.1
• outside IP address from DHCP, inside IP address—192.168.1.1
• DHCP server on inside interface, management interface
• Default route from outside DHCP
• ASDM access—Management and inside hosts allowed. Management hosts are limited to the
192.168.45.0/24 network, and inside hosts are limited to the 192.168.1.0/24 network.
• NAT—Interface PAT for all traffic from inside to outside.
• DNS servers—OpenDNS servers are pre-configured.
The configuration consists of the following commands:
Cisco Firepower 1010 Getting Started Guide
173
ASA Deployment with ASDM
Firepower 1010 Default Configuration

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English