Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
Firepower /ssa/logical-device/mgmt-bootstrap/ipv4* # set ip ip_address
mask network_mask
h) Exit management IP configuration scope:
Firepower /ssa/logical-device/mgmt-bootstrap/ipv4* # exit
i) Exit management bootstrap configuration scope:
Firepower /ssa/logical-device/mgmt-bootstrap* # exit
6) Commit the configuration:
commit-buffer
4.5.7.2 Create a ASA Logical Device via GUI
1) Choose Logical Devices to open the Logical Devices page.
The Logical Devices page shows a list of configured logical devices on the chassis. If no logical
devices have been configured, a message stating so is shown instead.
2) Click Add Device to open the Add Device dialog box.
3) For the Device Name, provide a name for the logical device.
4) For the Template, choose Cisco Adaptive Security Appliance.
5) For the Image Version, choose the ASA software version.
6) For the Device Mode, click the Standalone radio button.
7) Click OK.
You see the Provisioning - device name window.
8) Expand the Data Ports area, and click each port that you want to assign to the device.
9) Click the device icon in the center of the screen.
The ASA Configuration dialog box appears.
10) On the General Information tab, complete the following:
a) On multiple module devices, like the Firepower 9300, choose the security module that you want to
use for this logical device by clicking on it under Security Module Selection.
b) Select the management interface to use with the logical device from the Management Interface
drop-down list.
c) Under DEFAULT, configure the management interface:
This information is used to configure a management interface in the security module/engine
configuration. This management IP address is also the IP address you will use to connect to ASDM.
1 Select the type of address from the Address Type drop-down list.
2 In the Management IP field, configure a local IP address.
3 Enter a Network Mask or Prefix Length.
4 Enter a Network Gateway address.
11) On the Settings tab, enter a password for the "admin" user in the Password field.
12) Click OK to close the ASA Configuration dialog box.
13) Click Save.
To Next Page
Loading...
Need help?
General