Cisco Preparative Procedures & Operational User Guide
© 2016 Cisco Systems, Inc. All rights reserved.
4.6 Self-Tests
Cisco products perform a suite of FIPS 140-2 self-tests during power-up and re-boot. If any of the self-
test fails, the product will not enter operational state. If this occurs, please re-boot the appliance. If the
product still does not enter operational state, please contact Cisco Support (e-mail support@Cisco.com or
call us at 1-800-917-4134 or 1-410-423-1901).
The following possible errors that can occur during this self-test are:
Known Answer Test (KAT) failures
Zeroization Test failure
Software integrity failure
To Previous Page
Loading...
Need help?
General