Cisco IE 3000 Hardware Installation Guide

B-14
Cisco IE 3000 Switch Hardware Installation Guide
Appendix B Installation In a Hazardous Environment
Installing or Removing the Compact Flash Memory Card
Figure B-6 Pushing the Module Latches In
Step 6 If you are going to install a second expansion module to the switch expansion module combination,
follow Step 1 to Step 5
Note Refer to Table B-1 for a list of supported switch and expansion module combinations.
Installing or Removing the Compact Flash Memory Card
The switches store Cisco IOS software images and switch configurations on a removable flash memory
card. You can replace the switch without reconfiguring it. The switch ships with the compact flash
memory card installed. Verify that the card is in place on the bottom of the switch.
Warning Do not insert or remove the compact flash card while power is on; an electrical arc can occur. This
could cause an explosion in hazardous location installations. Be sure that power is removed or the
area is nonhazardous before proceeding. Statement 379
201826

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English