Part DescriptionQuantity
Grounding plate1
Step 1 Install the rack-mount brackets to the router as follows:
a) Determine which end of the chassis is to be located in the cold aisle as follows:
• If the router has port-side intake modules (fan modules with burgundy coloring), position the router so that the
ports are in the cold aisle.
• If the router has port-side exhaust modules (fan modules with blue coloring), position the router so that the fan
and power supply modules are in the cold aisle.
b) Position a rack-mount bracket on the side of the chassis with its four holes that are aligned to four of the screw holes
on the side of the chassis, and then use four M4 counter sink screws to attach the bracket to the chassis.
Remove the grounding cover label and align the grounding cover plate with the grounding holes in the
chassis and attach the rack mount brackets.
Note
You can align four of the holes in the rack-mount bracket to four of the screw holes on the front side of
chassis or four of the screw holes on the rear side of the chassis. The holes that you use depend on which
side your chassis need to be put in the cold aisle.
Note
Figure 27: Rack-Mount Brackets on Cisco—Port-Side Intake
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
39
Install the Chassis
Rack-Mount the NCS-57B1 Chassis in a 4-Post Rack
To Next Page
Loading...
Need help?
General
