Cisco NCS-57C3-MOD-SYS User Manual

Connecting a Cable to the GNSS Antenna Interface
The GNSS LED is located on the front side of the chassis.
Step 1 Connect one end of a shielded coaxial cable to the GNSS RF IN port.
Step 2 Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.
The GNSS RF In port should have a primary protector installed to meet the Local Safety guidelines.
Note
Figure 67: NCS 57B1 GNSS Port
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
83
Connect Router to the Network
Connecting a Cable to the GNSS Antenna Interface

Cisco NCS-57C3-MOD-SYS Specifications

General

Brand	Cisco
Model	NCS-57C3-MOD-SYS
Category	Network Router
Language	English