Cisco NCS-57C3-MOD-SYS User Manual

StatusColorLED
Critical alarm - system-scope (including RP0).
RedALRM
(ALARM)
Major alarm - system-scope (including RP0).Amber
No alarm.Off
SyncE PLL is locked to an input source.
GreenSYNC
SyncE PLL not-locked to any input source.Amber
SyncE not configured.Off
Fans are working normally.
GreenFAN
System is operating with one fan failure.Amber
Missing a fan or multiple fan failures.Red
Chassis not receiving power.
OffPOWER
Chassis powered on and normal.Green
Chassis powered off and in retry mode due to thermal or fan failure.Amber
Chassis power failure.
Power supply failure, due to one of the following conditions:
• Over voltage
• Over current
• Over Temperature
• Fan failure
Red
GNSS is not configured.
OffGNSS
GNSS is locked to an RF input (Satellites).Green
GNSS Receiver not-locked RF input (Satellites).Amber
Route Processor Card LEDs
On the NC57-MOD-RP2-E route processor card, the Status (STS), Active (ACT), and Attention (ATTN)
LEDs are located on the lower left front of the route processor card. The management port link and active
LEDs are located immediately below the port on the front of the module.
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
103
LEDs
Route Processor Card LEDs

Cisco NCS-57C3-MOD-SYS Specifications

General

Brand	Cisco
Model	NCS-57C3-MOD-SYS
Category	Network Router
Language	English