2-8
Cisco Video Surveillance PTZ IP Camera Installation Guide
OL-28954-01
Chapter 2 Installing the Camera
Installing the PTZ IP Camera
Mounting the PTZ Camera
Note Before mounting the camera, install an SD, SDHC, or SDXC card if you prefer recording to local
storage.
Step 1 Select a rigid mounting location to prevent vibration to the camera, and attach the alignment sticker to
the wall.
Note The camera weighs 3.66kg.
Step 2 Drill four pilot holes (10mm in diameter and 4cm deep) into the wall, and hammer in threaded anchors.
Note Hammer the anchors with hex nuts on them, so the threaded poles do not get deformed. If
preferred, drill another hole for routing cables.
Step 3 Secure the wall mount bracket to wall using four sets of captive washers and nuts.
Step 4 Align the camera body with the top section.
a. Align the alignment mark on the camera with that on the interface section.
b. Push the camera up to match the top section.
Step 5 Rotate the camera clockwise until its alignment mark is aligned with the "C" mark.
Step 6 Use the included T25 stardriver to securely tighten the three anti-tamper screws from the top.
1 Mount bracket
2 Interface section
3 Board-to-board connector
To Next Page
Loading...
Need help?
General
