EasyManuals Logo
Home>Cisco>Security Camera>PTZ

Cisco PTZ User Manual

Cisco PTZ
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
CHAPTER
3-1
Cisco Video Surveillance PTZ IP Camera Installation Guide
OL-28954-01
3
Performing the Initial Setup of the IP Camera
After you install the PTZ IP camera as described in the Chapter 2, “Installing the Camera, or after you
perform a factory reset procedure, you must access the PTZ IP camera and make initial configuration
settings. These settings include administrator and root passwords, and whether the PTZ IP camera can
be accessed through an HTTP connection in addition to the default HTTPS (HTTP secure) connection.
To make these configuration settings, you connect to the PTZ IP camera from any PC that is on the same
network as the PTZ IP camera. The PC must meet these requirements:
Operating system—Microsoft Windows 7 (32-bit and 64-bit)
Browser—Internet Explorer 8.0 (32-bit only)
In addition, you must know the IP address and default login credentials of the PTZ IP camera. By default,
when the PTZ IP camera powers on, it attempts to obtain an IP address from a DHCP server in your
network. If the camera cannot obtain an IP address through DCHP within 90 seconds, it uses a default
IP address of 192.168.0.100. The default login credentials (Username/Password) are admin/admin.
To connect to the PTZ IP camera for the first time and make initial configuration settings, perform the
following steps. You can change these configuration settings in the future as described in the Cisco
Video Surveillance PTZ IP Camera Configuration Guide.
Before you Begin
The Microsoft .NET Framework version 2.0 or later must be installed on the PC that you use to connect
to the PTZ IP camera. You can download the
.NET Framework from the Microsoft website.
Procedure
Step 1 Start Internet Explorer, enter HTTPS://ip_addres s in the address field, and press Enter.
Replace ip_address with the IP address that the PTZ IP camera obtained through DHCP or, if the camera
was unable to obtain this IP address, enter 192.168.0.100.
The Login window appears.
Step 2 Enter the default login credentials:
Username: admin
Password: admin
The Initialization window appears.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco PTZ and is the answer not in the manual?

Cisco PTZ Specifications

General IconGeneral
BrandCisco
ModelPTZ
CategorySecurity Camera
LanguageEnglish

Related product manuals