2-12
Cisco Video Surveillance PTZ IP Camera Installation Guide
OL-28954-01
Chapter 2 Installing the Camera
Connecting to the Network
Connecting to the Network
Use the following steps to connect the camera to a Power over Ethernet (PoE) switch:
Step 1 Connect the camera's Ethernet cable (CAT5e or better) to a PoE Plus switch.
A30W PoE output port alone cannot drive the onboard heater. If using the PoE switch, the
application does not apply in low-temperature condition. A 30W PoE plus can only drive the camera
when it is working at a temperature higher than -10ºC.
Step 2 Connect the power wires to an AC 24V power adaptor (user-supplied).
The AC 24V adapter can drive the camera and the onboard heater. You can connect both power
sources for redundancy in power supply.
If you are using a non-PoE switch, use a high power PoE power injector with a 60W output to connect
between the camera and non-PoE switch.
Sufficient power is required for low temperature conditions when the onboard heater is activated.
What to do next
• After you install the PTZ IP camera, follow the instructions in the “Performing the Initial Setup of
the IP Camera” section on page 3-1 to access the camera through your network.
• After completing the initial setup, use the PTZ IP camera user interface in the Managing the Camera
section to adjust the focal length and zoom factor.
For complete configuration information, refer to the Cisco Video Surveillance PTZ IP Configuration
Guide.
AC 24V 3.5A Adapter
(User-supplied)
IEEE 802.3at PoE Switch (30W output)
and / or
347715
347716
Non-PoE Switch
High Power PoE Power
Injector
To Next Page
Loading...
Need help?
General
