Cisco UCS B200 M3 User Manual

Cisco UCS B200 M3 Blade Server
CONFIGURING the SERVER
25
STEP 8 ORDER OPTIONAL INTERNAL USB 2.0 DRIVE
You may order one optional internal USB 2.0 drive. The USB drive ordering information is listed
in
Table 14.
See Figure 5 on page 36 for the location of the USB connector.
Table 14 USB 2.0 Drive
Product ID (PID) PID Description
UCS-USBFLSH-S-4GB 4GB Flash USB Drive (shorter) for all M3 servers
NOTE: A clearance of 0.950 inches (24.1 mm) is required for the USB device to be
inserted and removed (see the following figure).
NOTE: When the Cisco 4GB USB key is purchased with a server, it is pre-installed
into the internal USB port and held firmly in place with a clip to protect it from
shock and vibration during shipment and transportation. This clip also prevents the
USB key from undergoing shock and vibration during ongoing customer operational
use.

Cisco UCS B200 M3 Specifications

General

System bus rate	8 GT/s
Processor family	Intel
Processor socket	LGA 2011 (Socket R)
Intel Xeon series	E5-2600
Motherboard chipset	Intel C600
Compatible processor series	Intel® Xeon®
Number of processors supported	2
ECC	Yes
Memory form factor	240-pin DIMM
Number of DIMM slots	24
Supported memory types	DDR3-SDRAM
Maximum internal memory	768 GB
RAID levels	0, 1
Storage drive sizes supported	2.5 \
Supported storage drive interfaces	Serial Attached SCSI (SAS), Serial ATA III
USB 2.0 ports quantity	0
On-board graphics card model	Matrox G200
Chassis type	-
Product color	Silver
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	5 - 93 %
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	620 mm
Width	203 mm
Height	50 mm
Weight	4360 g