Cisco Valet M10 User Manual

22
Chapter 3: Advanced Configuration
User Guide
Security Mode
Select the security method for your wireless network:
WPA2/WPA Mixed Mode, WPA2 Personal, WPA Personal,
WPA2/WPA Enterprise Mixed Mode, WPA2 Enterprise, WPA
Enterprise, WEP, RADIUS, or Disabled.
WPA2/WPA Mixed Mode
NOTE: If you select WPA2/WPA Mixed Mode
as your Security Mode, each device in your
wireless network MUST use WPA2/WPA and the
same passphrase.
Security Mode > WPA2/WPA Mixed Mode
Passphrase Enter a Passphrase of 8-63 characters. The
setup software that you use to install your Valet and set
up your wireless network changes the default passphrase.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
WPA2 Personal
NOTE: If you select WPA2 Personal as your
Security Mode, each device in your wireless
network MUST use WPA2 Personal and the
same passphrase.
Security Mode > WPA2 Personal
Passphrase Enter a Passphrase of 8-63 characters. The
setup software that you use to install your Valet and set
up your wireless network changes the default passphrase.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
WPA Personal
NOTE: If you select WPA Personal as your
Security Mode, each device in your wireless
network MUST use WPA Personal and the same
passphrase.
Security Mode > WPA Personal
Passphrase Enter a Passphrase of 8-63 characters. The
setup software that you use to install your Valet and set
up your wireless network changes the default passphrase.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
WPA2/WPA Enterprise Mixed Mode
This option features WPA2/WPA used in coordination with
a RADIUS server. (This should only be used when a RADIUS
server is connected to the Valet.)
NOTE: If you select WPA2/WPA Enterprise
Mixed Mode as your Security Mode, each
device in your wireless network MUST use
WPA2/WPA Enterprise and the same shared key.
WPA2/WPA Enterprise Mixed Mode
RADIUS Server Enter the IP address of the RADIUS server.
RADIUS Port Enter the port number of the RADIUS
server. The default is 1812.
Shared Key Enter the key shared between the Valet and
the server.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.

Cisco Valet M10 Specifications

General

Brand	Cisco
Model	Valet M10
Category	Wireless Router
Language	English