PRECAUTIONS
Always follow safe operating procedures, any national or local regulations and site
specific instructions.
Always turn the power off to the unit and properly isolate so power cannot be turned on by
mistake.
Turn off isolating valves to the dispenser and drain the fuel before any mechanical servicing.
Electrical Safety
Observe the following electrical precautions:
Always turn off the power to the Compac C5000 processor before opening the flame proof box.
Never touch wiring or components inside the high voltage area with the power on.
Always turn off the power to the Compac C5000 processor at the mains switch before removing
or replacing software or memory ICs.
Always take basic anti-static precautions when working on the electronics, i.e., wearing a
wristband with an earth strap.
Site Safety
Obey all company regulations and site specific instructions relating to the installation. Before
working on any hydraulic equipment, drain the dispenser in an approved manner.
Static Electricity Precautions
Electronic components used are sensitive to static. Please take anti-static precautions.
All circuit boards must be carried and transported in static-shielded bags. An anti-static wrist
strap should be worn and connected correctly when working on any electronic equipment. If an
anti-static wrist strap is unavailable, or in an emergency, hold onto an earthed part of the
pump/dispenser frame whilst working on the equipment. This is not a recommended alternative
to wearing an anti-static wrist strap.
Compac Industries Limited reserves the right to refuse to accept any returned circuit boards if
proper anti-static precautions have not been taken.
To Next Page
Loading...
Need help?
General
