!:i! !ii!i i¸I!!ii/! i ill! !
H
YEAR WARRANTY ON CRAFTSMAN STATIONARY TOOL
ie toa defect in material or workmanship within one year from the date
purchasei CONTACT THE NEAREST SEARS SERVICE CENTER iN THE UNITED STATES and
: Sears will repair it, free of charge,
This warranty applies only while this prodUct is in the United States.
this jointer/planer is used for commercial or rental purposes, this warranty will apply for ninety
days from the date of purchases.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to statei
Sears, Roebuck and Co., D/817 WA Hoffman Estates, IL 60179
Safety instructions For Jointer/Planer ....
Safety is a combination of common sense, staying alert and knowing how your jointer/planer works. Read this manual
to understand this tool.
J ±J ..... -==-..-Juu--=__ i_ _ iiiii, i
Safety Signal Words WARNING: means if the safety information is not followed
DANGER: means if the safety information is not followed someone could be seriously injured or killed.
someone will be seriously injured or killed. CAUTION: means if the safety information is not followed
someone may be injured.
, u .......
Before Using the Jointer/Pianer
WARNING: To avoid mistakes that could cause
serious, permanent injury, do not plug the jointer/
planer in until the following steps have been satis-
factorily completed.
Know and Understand the JointertPlaner
* Completely assemble and align jointer/planer.
Z
. Learn the use and function of the ON-OFF switch, _.
fence slide locking handle, cutter guard; depth of cut
hand wheel. Iocks and stops, fence bevel lock handle,
outfeed table, infeed table and hold-down/push-blocks. <_
• Review and understand all safety instruCtions and
operating procedures in this manual.
'.....
• Review the maintenance methods for this jointed
planer.
When Installing Or Moving the Jointer/Pianer
Avoid Dangerous Environment.
• Use the jointer/planer in a dry, indoor place protected
from rain
° Keep work area well lighted.
To avoid injury from unexpected jointer/planer move-
ment.
• Bolt or clamp the jointeriplaner to firm level surlace
where there is plenty of room for moving the workpiece
through the entire cut.
- Support the jointer/planer so the tables are level and
the jointer/planer does not rock.
• Put the iointer/planer where neither operators nor
bystanders must stand in line with the wood while
planing or jointing it.
, Find and read the warning label found on the jointeri
planer (shown below).
-To avoid injury from electrical shock, make sure your
fingers do not touch the plug's metal prongs when
plugging in or unplugg{ng the jointer/planer.
• Turn off and unplug the jointer/planer before moving it
to a new area. To avoid back injury, get help when you
need to lift or move the jointedplaner.
-Bolt the jointer/planer to the floor if it tends to slip,
walk slide or tip over. Be especially aware of move-
ment when jointing/planing long heavy boards.
° Never Stand On Tool. Serious injury could occur if the
tool tips or you accidentally hit the cutter head. Do not
store anything above or near the tool where anyone
might stand on the tool to reach them,
2
To Next Page
Loading...
Need help?
General