Getting to Know Your Jointer/Planer
5
3 //8
4
5
11
WARNING: For your own safety always lock the
switch "OFF" when jointertplaner is not in use.
Remove key and keep it in a safe place, also, in the
event of a power failure, turn switch off. Lock it
and remove the key. This will prevent the jointed
planer from starting up again when the power
comes back on.
For your own safety turn switch "OFF" and remove
plug from power source outlet before making any
adjustments.
WARNING: Read, understand and perform entire
"Adjustment" section before turning on the jointed
planer.
1. Depth of Cut Handwheei
By turning the handwheel you can control how much
wood will be removed from the workpiece on each
cut.
2. Cutter Head Guard:
Helps protect the operator from the sharp knives on
the cutterhead, It is spring loaded so it automatically
keeps the cutterhead covered before, during, and
after a cutting operation. It must always be used.
3. Fence Sliding Knob
Allows fence to move across table front to back. This
is done to achieve fult widthof cut orto use a different
(sharper) part of blade.
4.90 ° and 45° Fence Stops
When adjusted properly, these stops provide a
method for quickly moving the fence to a 90° or 45 °
position from the tab.le.
5. Fence Tilt (Bevel) Knob
For convenient, rigid locking of the fence.
6. Fence
Tilts and locks for 90° and angular movements.
7. Ouffeed Table
The section of a jointer bed which supports the work-
piece after it passes over the cutter.
8, Infeed Table
The section of the jointer bed upon which the work-
piece is placed before being pushed into the cutter.
Its height is adjustable which allows the operator to
select the depth of cut.
9. Table Lock Screw - When desired, use these
screws to lock infeed or outfeed table at a desired
height.
Nameplate Model/Serial
Belt Guard
Protects user from incidental access to the motor be_t
and pulleys.
10,
11.
17
To Next Page
Loading...
Need help?
General