Crestron PRO3 Supplemental Guide

iii. Press and hold the left button on the Nav Pad to delete a character.
iv. Press and hold the right button on the Nav Pad to insert a character.
v. Press the center button of the Nav Pad to save the new domain
name or press
BACK
to cancel.
b. Press up or down on the Nav Pad to highlight
Password
, and then
press the center button of the Nav Pad to enter the password that was
chosen.
My Crestron Edit Password Screen
i. Use the left and right buttons on the Nav Pad to select a character to
change.
ii. Use the up and down buttons on the Nav Pad to browse the list of
possible characters.
iii. Press and hold the left button on the Nav Pad to delete a character.
iv. Press and hold the right button on the Nav Pad to insert a character.
v. Press the center button of the Nav Pad to save the new hostname or
press
BACK
to cancel.
Once the domain name and passwords are entered, the control system registers itself with
MyCrestron every 5 minutes. To force an immediate registration, press up or down on the
Nav Pad to highlight
Register This System
, and then press the center button on the Nav
Pad.
To view the status of the connection to the MyCrestron.com service, press up or down on
the Nav Pad to highlight
Status
, and then press the center button on the Nav Pad. The
display shows the current IP address, the IP address when the system last checked, and
when the system last registered successfully with the MyCrestron.com service.
Ethernet Diagnostics
Use the PRO3’s built-in Ethernet diagnostic tools to perform various troubleshooting steps.
Tests can be run on the PRO3 to verify network connections. Use the up or down buttons
on the Nav Pad to highlight the desired test, and then press the center button on the Nav
Pad to start it.
Select
Ping Def. Router
to test the router connection. When the test is completed, the
results are shown on the display.
To verify external communications, select
Ping Crestron.com
. When the test is completed,
the results are shown on the display.
Select
Who
to display a list of devices that are connected to the control system via the
Ethernet connection. These devices may be Crestron Ethernet devices, third party Ethernet
My Crestron - Edit
Password
[P]ASSWORD
Press ‘Select’ to Save or ‘BACK’ to Cancel.
Press and Hold ‘Left’ to Delete.
Press and Hold ‘Right’ to Insert.
10 • PRO3: 3-Series Control System Supplemental Guide – DOC. 7330D

Crestron PRO3 Specifications

General

Brand	Crestron
Model	PRO3
Category	Control Systems
Language	English