Crestron PRO3 Supplemental Guide

devices, and PCs (including any PC using Crestron Toolbox to connect to the processor
over Ethernet).
NOTE:
Changing the CIP Port to something other than 41794 results in disabling access to
this setup program from a Web browser. In order to re-enable access, use Crestron
Toolbox to connect to the control system, and set the CIP Port back to 41794.
Application Settings
Select
Application Settings
to display the
Application Settings
menu.
Application Settings Menu
The
Application Settings
menu displays all of the programs that are loaded on the PRO3.
Press up or down on the Nav Pad to highlight the desired program, and then press the
center button of the Nav Pad to display controls for registering the program, starting or
stopping the program, viewing the program’s IP table, or viewing the program’s comments.
Application 1 Screen
Register and Unregister Programs
Before a program can be started, it has to be registered. At startup, only the registered
programs are started.
To register or unregister a program, press up or down on the Nav Pad to highlight
Register/Unregister
, and then press the center button of the Nav Pad. If the program is not
registered, it becomes registered and an asterisk appears. If a program is already
registered, it becomes unregistered and the asterisk disappears.
Start and Stop Programs
A program that is running can be stopped and a program that is not running can be started.
To start or stop a program, press up or down on the Nav Pad to highlight
Start/Stop
, and
then press the center button of the Nav Pad. If the program is not running, it starts and an
asterisk appears. If a program is running, it is stopped and the asterisk disappears.
Application Settings
1: V1A
2: SMITH RESIDENCE
3: PROTOTYPE
4: DEMO
5:
Application 1
* Register/Unregister
* Start/Stop
IP Table
Comments
Supplemental Guide – DOC. 7330D PRO3: 3-Series Control System • 11

Crestron PRO3 Specifications

General

Brand	Crestron
Model	PRO3
Category	Control Systems
Language	English