26D-Link DIR-818LW User Manual
Section 3 - Conguration
Select PPPoE (Username/Password) from the drop-down menu.
In most cases, select Dynamic IP. Select Static IP if your ISP assigned
you the IP address, subnet mask, gateway, and DNS server addresses.
Enter the IP Address (Static PPPoE only).
Enter your PPPoE Username.
Enter your PPPoE Password and retype the password in the next box.
Enter the ISP Service Name (optional).
Select either Always-on, On-Demand, or Manual.
Enter a Maximum Idle Time during which the Internet connection
is maintained during inactivity. Enable Auto-reconnect to disable
this feature.
Select Receive DNS from ISP or Enter DNS Manually.
Enter the Primary and Secondary DNS Server Addresses of your
choice or enter DNS Server Addresses supplied by your ISP.
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specic ISP. 1492 is the default
MTU.
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can click on Clone Your PC’s MAC
Address to replace the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet
Connection is:
Address Mode:
IP Address:
Username:
Password:
Service Name:
Reconnect Mode:
Maximum Idle Time:
DNS Mode:
DNS Servers:
MTU:
MAC Address:
Internet Setup
PPPoE (DSL)
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP (Internet Service Provider) uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software
is no longer needed and will not work through a router.
To Next Page
Loading...
Need help?
Network Interfaces
