34D-Link DAP-1350 User Manual
Section 3 - Configuration
Save to Local
Hard Drive:
Upload from
Local Hard Drive:
Restore to
Factory Default:
Reboot the
Device:
Use this option to save the current access point
configuration settings to a file on the hard disk of
the computer you are using. Click the Save button.
You will then see a file dialog where you can select
a location and file name for the settings.
Use this option to load previously saved access
point configuration settings. Click Browse to find a
previously saved configuration file. Then, click the
Upload Settings button to transfer those settings
to the access point.
This option will restore all configuration settings
back to the settings that were in effect at the time
the access point was shipped from the factory.
Any settings that have not been saved will be lost,
including any rules that you have created. If you
want to save the current access point configuration
settings, use the Save button above.
Note: Restoring the factory default settings will not
reset the Wi-Fi Protected Status to Not Configured.
Click to reboot the access point.
System
To Next Page
Loading...
Need help?
General
Weight and Dimensions
