DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
Using WPS Function without Web-based Interface
You can use the WPS function without accessing the web-based interface of the router. To do this,
you need to configure the following router's settings:
1. Specify relevant security settings for the wireless network of the router.
2. Make sure that the Enable Wi-Fi when WPS function is activated with hardware
button switch is moved to the right on the tabs of both bands.
3. Click the ENABLE WPS button.
4. Сlose the web-based interface (click the Logout line of the menu).
Later you will be able to add wireless devices to the WLAN by pressing the WPS button of the
router.
1. Select the PBC method in the software of the wireless device that you want to connect to the
router's WLAN.
2. Click the relevant button in the software or press the WPS button on the cover of the
wireless device that you want to connect to the WLAN.
3. Press the WPS button of the router, hold it for 2 seconds, and release. The WLAN 2.4G and
WLAN 5G LEDs will start blinking.
Page 165 of 303