D-Link DNS-343 User Manual
25
RAID Page
The DNS-343 supports the following configuration types:
Standard, where each drive is a unique volume, JBOD, which combines both drives in
a linear fashion to create one volume, RAID 1 and RAID 5 with a Basic Configuration
and a combination of RAID 0/JBOD, RAID 1/JBOD and RAID 5/JBOD for Custom
Configuration.
Click Set RAID Type and Re-Format to
change the current drive configuration.
If you already have one drive installed and intend to
install additional drives, the DNS-343 allows you
to change the drive configuration from Standard to
JBOD, RAID 1, RAID 5 or a combination of RAID0/
JBOD, RAID1/JBOD or RAID5/JBOD.
If you have installed an additional hard drive and
“skipped” the configuration, you will see there is an
additional option allowing you to configure the new
hard drive. This will erase all the data stored on the
new hard drive.
Select to enable or disable Auto-Rebuild Configuration.
When the DNS-343 has been configured
as a RAID array the Auto-Rebuild function
allows a degraded RAID array to rebuild when the
failed hard drive is replaced by restoring data from the
existing hard drives to the newly inserted hard drive.
RAID Conguration:
Congure Newly
Inserted Hard
drive(s):
Auto-Rebuild
Conguration:
Please Note:
Rebuilding will erase all the data on the newly inserted drive.
To Next Page
Loading...
Need help?
General
