xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
110
NOTE: The Switch supports up to 4k static VLAN entries.
Figure 3 - 6 Static VLAN window – Modify
The following fields can then be set in either the Add or Modify 802.1Q Static VLANs windows:
Parameter Description
Unit
Select the switch in the switch stack for which to configure VLANs.
VID (VLAN ID)
Allows the entry of a VLAN ID in the Add window, or displays the VLAN ID of an existing VLAN in
the Modify window. VLANs can be identified by either the VID or the VLAN name.
VLAN Name
Allows the entry of a name for the new VLAN in the Add window, or for editing the VLAN name in
the Modify window.
Advertisement
Enabling this function will allow the Switch to send out GVRP packets to outside sources,
notifying that they may join the existing VLAN.
Port Settings
Allows an individual port to be specified as member of a VLAN.
Tag
Specifies the port as either 802.1Q tagging or 802.1Q untagged. Checking the box will designate
the port as Tagged.
None
Allows an individual port to be specified as a non-VLAN member.
Egress
Select this to specify the port as a static member of the VLAN. Egress member ports are ports
that will be transmitting traffic for the VLAN. These ports can be either tagged or untagged.
Forbidden
Select this to specify the port as not being a member of the VLAN and that the port is forbidden
from becoming a member of the VLAN dynamically.
Click Apply to implement changes made.
To Next Page
Loading...
Need help?
General