xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
109
classification. The Switch supports fourteen pre-defined protocols for configuration. The user may also choose a protocol that is
not one of the fourteen defined protocols by properly configuring the userDefined protocol VLAN. The supported protocols for
the protocol VLAN function on this switch include IP, IPX, DEC LAT, SNAP, NetBIOS, AppleTalk, XNS, SNA, IPv6, RARP
and VINES.
Static VLAN Entry
This window is used to create static VLAN entries on the Switch.
To view this window click, L2 Features > VLAN > Static VLAN Entries as shown below:
Figure 3 - 4 Current Static VLAN Entries window
The Current Static VLAN Entries window lists all previously configured VLANs by VLAN ID and VLAN Name. To delete an
existing 802.1Q VLAN, click the corresponding
button under the Delete heading.
To create a new 802.1Q VLAN, click the Add button in the Current Static VLAN Entries window. A new window will appear,
as shown below, to configure the port settings and to assign a unique name and number to the new VLAN. See the table below for
a description of the parameters in the new window.
Figure 3 - 5 Static VLAN window – Add
To return to the Current Static VLANs Entries window, click the Show All Static VLAN Entries link. To change an existing
802.1Q VLAN entry, click the Modify button of the corresponding entry to modify. A new menu will appear to configure the port
settings and to assign a unique name and number to the new VLAN. See the table below for a description of the parameters in the
new menu.
To Next Page
Loading...
Need help?
General