xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
115
Figure 3 - 12 Double VLAN Information window
Parameters shown in the previous window are explained below:
Parameter Description
SPVID
The VLAN ID number of this potential Service Provider VLAN.
VLAN Name
The name of the VLAN on the Switch.
TPID
The tagged protocol ID of the corresponding VLAN that will be used in identification of this
potential Double VLAN, written in hex form.
Uplink Ports
These ports are set as uplink ports on the Switch. Uplink ports are for connecting Switch VLANs
to the Service Provider VLANs on a remote source.
Access Ports
These are the ports that are set as access ports on the Switch. Access ports are for connecting
Switch VLANs to customer VLANs.
Unknown Ports
These are the ports that are a part of the VLAN but have yet to be defined as Access or Uplink
ports.
To create a Double VLAN, click the Add button, revealing the following window for the user to configure.
Figure 3 - 13 Double VLAN Creation window
To create a Double VLAN, enter the following parameters and click Apply.
Parameter Description
VLAN Name
Enter the pre-configured VLAN name to create as a Double VLAN.
SPVID
Enter the VID for the Service Provider VLAN with an integer between 1 and 4094.
TPID
Enter the TPID in hex form to aid in packet identification of the Service Provider VLAN.
To Next Page
Loading...
Need help?
General