xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
87
Figure 2 - 95 sFlow Counter Poller Settings window
The following fields are displayed:
Parameter Description
Port
Displays the port from which packet counter samples are being taken.
Analyzer Server ID
Displays the ID of the Analyzer Server where datagrams, containing the packet counter polling
information taken using this polling mechanism, will be sent.
Polling Interval
(sec)
The Polling Interval displayed here, is measured in seconds and will take a poll of the IF
counters for the corresponding port, every time the interval reaches 0 seconds.
Modify
Click this button to modify the settings for this entry. The sFlow Sampler Settings Edit
window will be produced for the user to configure.
Delete
Click the corresponding
button of the entry to be deleted.
To delete all the entries in the table click the Clear All button. To add a new sFlow Counter Poller setting, click the Add button
which will display the following window to be configured.
Figure 2 - 96 sFlow Counter Poller Add window
The following fields may be set:
Parameter Description
Unit
Select the unit you wish to configure.
From…To
Choose the beginning and ending range of ports to be configured for counter polling.
Analyzer Server ID
(1-4)
Enter the previously configured Analyzer Server ID to state the device that will be receiving
datagrams from the Switch. These datagrams will include the counter poller information taken
using the polling mechanism configured here.
Polling Interval (20-
Users may configure the Polling Interval here. The switch will take a poll of the IF counters
To Next Page
Loading...
Need help?
General