L. Crank Case Cover/Kick Starter/Continuously Variable Transmission
Kick Starter Assembly
● Assemble the kick starter idle gear shaft and the
kick driven gear comp to the left cover.
NOTE
● As shown in the figure, match the kick driven
gear friction spring with the L. crank case cover
groove, and assemble.
● Match the kick starter spindle with the idle gear
punch mark, and assemble.
● Hold, and turn, in reverse, the kick return spring
arm.
● Assemble the kick stopper plate.
Drive Belt
Removal
● Remove L. crank case cover. ( 7-2)
● Loosen the clutch outer setting nut with a
universal holder.
Tool: Universal holder
7-7
Setting nut
Driven gear
Idle gear
OIL
Apply grease to the spring groove, kick driven
gear, and idle gear wedge.
To Next Page
Loading...
Need help?
General
