SiBE18-821_C RA Indoor Unit
Operation Manual 249
To use ON TIMER operation
•
1. Press “ON TIMER button”.
is displayed.
blinks.
2.
3. Press “ON TIMER button” again.
4. Press “CANCEL button”.
To combine ON TIMER and OFF TIMER
ATTENTION
4
2
1, 3
Check that the clock is correct. If not, set the
clock to the present time.
Press “TIMER Setting button” until
the time setting reaches the point
you like.
• Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
To cancel ON TIMER
operation
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
• A sample setting for combining the two timers is shown below.
• The TIMER lamp goes off.
•
The TIMER lamp lights up.
To Next Page
Loading...
Need help?
General
