1.9 Automatic adjustments
When living eco® is installed it will automatically begin to adjust itself to your heating system.
During this process you might experience that the thermostat reacts slowly or turns the heat up
and down by itself. This is normal and a necessary part of the adjustment process.
1. Adjusting to the valve
During the first night of operation living eco® will shut off the radiator heat and then open again
to detect the exact opening point of the valve. This will allow living eco® to control the heat as ef-
ficiently as possible. If necessary, the procedure is repeated once a night for up to a week.
2. Intelligent Control (Forecast)
During the first week of operation living eco® learns when it is necessary to start heating the room
in order to reach the correct temperature at the correct time.
The intelligent control will continuously adjust the heating time compared to seasonal tempera-
ture changes.
Using Saving Program requires that your heating system has enough heat for a short period during
heat up. If your experience problems you should contact your installer.
1.10 Removing living eco®
1. 2.
Activate Installation Mode: Press for 3
seconds to select the Function Menu.
Select M with . When M flashes, press .
A large M is flashing in the display to indicate
that Installation Mode is activated.
3. 4.
Remove the battery cover and the batteries. Insert the Allen key or similar into the hole to
lock the adapter ring. Turn counterclockwise
to unscrew living eco® from the adapter.
Installation Guide living eco® Electronic Radiator Thermostat
To Next Page
Loading...
Need help?
General
