PVG 16 technical data overview
Only an overview of technical data is shown below; for comprehensive data, please see the Technical
Information document for PVG 16.
PVEO/PVEO-CI control specifications
Description Type Value
Supply Voltage (Udc) Rated 12 Vdc 24 Vdc
Range 11 to 15 Vdc 22 to 30 Vdc
Max. ripple 5% 5%
Current consumption Typical 320 mA 160 mA
PVEA/PVEA-CI/PVEA-F control specifications
Supply voltage (Udc) Rated 11 to 32 Vdc
Range 11 to 32 Vdc
Max. ripple 5%
Signal voltage (Us) Neutral 0.5 Udc
Q: P → A 0.25 Udc
Q: P → B 0.75 Udc
Current consumption @ 12 Vdc 320 mA
@ 24 Vdc 170 mA
Input impedance Rated 12 kΩ
Input capacitance Rated 100 µF
Operating conditions
Pilot pressure Nominal 13.5 bar [196 psi]
Minimum 10.0 bar [145 psi]
Maximum 15.0 bar [218 psi]
Oil consumption Neutral 0.04 l/min [0.01 US gal/min]
Locked position 0.04 l/min [0.01 US gal/min]
Actuating 0.6 l/min [0.16 US gal/min]
Storage temperature Ambient -50 to +90°C [-58 to +194°F]
Operating temperature Ambient -40 to +90°C [-40 to +194°F]
Oil viscosity Operating range 12 to 75 mm
2
/sec [65 to 347 SUS]
Minimum 4 mm
2
/sec [39 SUS]
Maximum 460 mm
2
/sec [2128 SUS]
Oil cleanliness Minimum 18/16/13 (according to ISO 4406)
PVG 16 connector variants
PVG 16 connector variants for PVEO, PVEA, PVEO-CI, PVEA-CI, PVEA-F with pin layout information.
Service and Parts Manual
PVG 16/32/128/256
Installation
©
Danfoss | October 2018 AX284661889190en-000101 | 19
To Next Page
Loading...
Need help?
General
