VLT
®
6000 HVAC Series
All about VLT 6000
HVAC
PNU Parameter Factory setting Range Changes 4-Setup Conversion Data
# description during operation index ype
600 Operating data: Operating hours No No 74 7
601 Operating data: Hours run No No 74 7
602 Operating data: kWh counter No No 3 7
603 Operating data: Number of cut-ins No No 0 6
604 Operating data: Number of overtemps No No 0 6
605 Operating data: Number of overvoltages No No 0 6
606 Data log: Digital input No No 0 5
607 Data log: Control word No No 0 6
608 Data log: Status word No No 0 6
609 Data log: Reference No No -1 3
610 Data log: Feedback No No -3 4
611 Data log: Output frequency No No -1 3
612 Data log: Output voltage No No -1 6
613 Data log: Output current No No -2 3
614 Data log: DC link voltage No No 0 6
615 Fault log: Error code No No 0 5
616 Fault log: Time No No 0 7
617 Fault log: Value No No 0 3
618 Reset of kWh counter No reset Yes No 0 5
619 Reset of hours-run counter No reset Yes No 0 5
620 Operating mode Normal function Yes No 0 5
621 Nameplate: Unit type No No 0 9
622 Nameplate: Power component No No 0 9
623 Nameplate: VLT ordering no. No No 0 9
624 Nameplate: Software version no. No No 0 9
625 Nameplate: LCP identification no. No No 0 9
626 Nameplate: Database identification no. No No -2 9
627 Nameplate: Power component identification no. No No 0 9
628 Nameplate: Application option type No No 0 9
629 Nameplate: Application option ordering no. No No 0 9
630 Nameplate: Communication option type No No 0 9
631 Nameplate: Communication option ordering no. No No 0 9
655 Fault log: Real time No No -4 7
Changes during operation:
"Yes" means that the parameter can be changed,
while the frequency converter is in operation. "No"
means that the frequency converter must be stopped
before a change can be made.
4
-Setup:
"Yes" means that the parameter can be programmed
individually in each of the four setups, i.e. the
same parameter can have four different data
values. "No" means that the data value will be
the same in all four setups.
C
onversion index:
This number refers to a conversion figure to
be used when writing or reading by means
of a frequency converter.
Conversion index Conversion factor
74 0.1
2 100
110
01
-1 0.1
-2 0.01
-3 0.001
-4 0.0001
Data type:
Data type shows the type and length of the telegram.
Data type Description
3Integer16
4Integer32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9Textstring
MG.61.A5.02 - VLT is a registered Danfoss trademark
167