Danfoss VLT Compact Starter MCD 201 User Manual

6 Operation
The EtherNet/IP Module is conformance tested to ODVA. For successful operation, the scanner must also support all
functions and interfaces described in this manual.
6.1 Device Conguration
The EtherNet/IP Module is an Adapter class device and must be managed by a Scanner class device over Ethernet.
6.2 Scanner Conguration
6.2.1 EDS File
Download the EDS le from drives.danfoss.com/services/pc-tools. The EDS le contains all required attributes of the
EtherNet/IP Module.
Once the EDS le is loaded, the individual EtherNet/IP Module must be dened.
6.3 LEDs
LED name LED status Description
1 2
TX/RX 2
TX/RX 1
Link 2
Link 1
Error
Status
Power
177HA627.10
Power
O The module is not powered up.
On The module receives power.
Error
O The module is not powered up or does not have an IP address.
Flashing Connection timeout.
On Duplicate IP address.
Status
O The module is not powered up or does not have an IP address.
Flashing The module has obtained an IP address but has not established any network
connections.
On Communication has been established.
Link x
O No network connection.
On Connected to a network.
TX/RX x Flashing Transmitting or receiving data.
Table 6.1 Feedback LEDs
Operation EtherNet/IP Module
12 Danfoss A/S © 05/2017 All rights reserved. MG17Q102
6
6

Danfoss VLT Compact Starter MCD 201 Specifications

General

Brand	Danfoss
Model	VLT Compact Starter MCD 201
Category	Controller
Language	English