Danfoss vlt FC 102 User Guide

1 Introduction
1.1 Purpose of the Manual
This manual provides detailed information for startup and
commissioning of the drive system composed of VLT
®
Parallel Drive Modules. Chapter 4 Commissioning provides
detailed procedures for basic programming, pre-startup
testing, and startup.
The remaining chapters provide supplementary details,
including:
•
The user interface.
•
Detailed programming.
•
Application examples.
•
Operational troubleshooting.
•
Specications.
This user guide is intended for use by qualied personnel.
To operate and maintain the drive system safely and
professionally, read and follow the user guide. Pay
particular attention to the safety instructions and general
warnings. Always keep this user guide with the drive
system.
VLT
®
is a registered trademark.
1.2
Additional Resources
Other resources are available to understand the functions
and programming of the VLT
®
Parallel Drive Modules.
•
The VLT
®
Parallel Drive Modules 250–1200 kW
Design Guide contains detailed information about
the capabilities and functionality of motor control
systems using these drive modules, and provides
guidance for designing this type of system.
•
The VLT
®
Parallel Drive Modules 250–1200 kW
Installation Guide provides instructions for
mechanical and electrical installation of these
drive modules.
•
Refer to the FC 102, FC 202, or FC 302 VLT
®
Drive
Programming Guide applicable to the particular
series of VLT
®
Parallel Drive Modules used in
creating the drive system. The programming
guide describes in greater detail how to work
with parameters and provides application
examples.
•
The VLT
®
FC Series, D-frame Service Manual
contains detailed service information, including
information applicable to the VLT
®
Parallel Drive
Modules.
•
The VLT
®
Parallel Drive Modules DC Fuses Instal-
lation Instructions contain detailed information
about installing the DC fuses.
•
The VLT
®
Parallel Drive Modules Bus Bar Kit Instal-
lation Instructions contain detailed information
about installing the busbar option kit.
•
The VLT
®
Parallel Drive Modules Duct Kit Instal-
lation Instructions contain detailed information
about installing the duct option kit.
Refer to other supplemental publications and manuals,
available from Danfoss. See vlt-drives.danfoss.com/support/
technical-documentation/ for listings.
1.3 Manual and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the manual version and the corresponding software
version.
Manual
version
Remarks Software version
MG37L2xx Update to Drive
System section
FC 102 (5.0x), FC 202 (3.0x),
FC 302 (7.6x)
Table 1.1 Manual and Software Version
1.4
Approvals and Certications
Table 1.2 Approvals
1.5
Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Introduction
VLT
®
Parallel Drive Modules
4 Danfoss A/S © 08/2017 All rights reserved. MG37L202
11

Danfoss vlt FC 102 Specifications

General

Brand	Danfoss
Model	vlt FC 102
Category	DC Drives
Language	English