34 Elements of Card Design
Smart Card Codes on the Printer Label
The configuration label includes codes that identify the type and model of the smart card module
installed in the printer. The following table lists the codes used on the configuration label.
The S1 value on the configuration label indicates that the printer has the basic smart card
components installed. Basic components include the mounting hardware only. An integrator
must install a contactless reader.
If the Sx value is included in the configuration code, the printer has the basic components of an
S1, plus the appropriate interface installed.
Code on Label Type of Smart Card Module
S1 Integrator Contactless
S3 HID pcProx Contactless
S4 iCLASS Read Contactless
S5 iCLASS Read/Write Contactless
S6 DUALi Standard
S7 DUALi Single Wire
S8 DUALi Single Wire Sony Felica
S9 GEMPC USB / pcProx Dual
S10 Contact Station
S11 Identive Dual Interface Reader
S12 pcProx Plus Dual Frequency
S13 DUALi Single Wire Large Memory
The smart card readers available may vary by printer model. Contact your authorized
dealer for more information.