176 Magellan
®
2200VS/2200VS and 2300HS/2300HS
Keyboard Interface — Control Characters
Specifies how the scanner transmits ASCII control characters to the host.
Choices are:
• Disable Control Characters
• Enable transmission of control characters to host
• Send characters between 00H and 1FH according to a special func-
tion-key mapping table. (This is used to send keys that are not in
the normal ASCII set; a unique set is provided for each available
scancode set. Reference
Appendix F, Keyboard Function Key Map-
pings
.)
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your choice from the Control Characters feature bar codes
below. You’ll need to cover any unused bar codes on this and the fac-
ing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
CONTROL CHARACTERS = DISABLE
NOTE
This feature does not apply to the USB Keyboard interface.
To Next Page
Loading...
Need help?
General
