Datalogic PowerScan PD9530 Quick Reference Guide

Setting Up the Reader
Quick Reference Guide 7
Connecting the Cable
A. Rubber gasket
B. Cable Holder
C. Cover
D. Connector Holder
1. Slip the cable through the
Cover.
2. Push the Rubber Gasket
onto the Cable Holder.
3. Push the Cable Holder
and gasket into the handle.
Ensure that the “Front”
marking on the Cable
Holder is facing out, with
the arrow pointing
towards the front of the
scanner.
4. Insert the end of the cable
into the socket of the
Cable Holder.
5. Push the Cover along the
cable towards the reader,
and hook it over the yel-
low “tooth” on the back of
the handle.
6. Insert the cable through
the Connector Holder,
and push it up into the
Cover.
7. Insert and tighten the
screw to affix the cable
assembly to the reader
handle.
A
B
C
D
FRONT>>
1
2
3
6
4
5
7

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g