Load <src> with <x>
<src> is a tray or feeder, and <x> is a paper type or size.
Try one or more of the following:
• Load the paper tray or other source with the correct paper type and size.
• Cancel the current job.
Load staples
Try one or more of the following:
• Replace the specified staple cartridge in the finisher.
• Press the arrow buttons until
Continue appears, and then press to clear the message and continue printing.
• Cancel the print job.
Maintenance
Replace the maintenance items and, if necessary, reset the printer maintenance counter.
For information on purchasing supplies, see “Ordering supplies” on page 165.
Menu access turned off by system administrator
The printer menus cannot be accessed because your system support person disabled the menus. Wait for the message
to clear.
Menus are Disabled
The printer menus are disabled. The printer settings cannot be changed from the printer control panel. Contact your
system support person for help.
Note: When menus are disabled, it is still possible to cancel a print job, print a confidential job, or print a held job.
Must be in Ready state to enter menus
The printer menus cannot be accessed at this time because the printer control panel does not show the Ready
message. Wait for the printer to complete its activity. When Ready appears, press
.
Network/Network <x>/Network <x>, <y>
The printer is connected to the network, so the network interface is the active communication link.
• Network indicates that the printer is using the standard network port built into the printer system board.
• Network <x> indicates that an internal print server is installed inside the printer or that the printer is connected
to an external print server.
Understanding printer messages
148
To Next Page
Loading...
Need help?
General