Removing and Installing Parts 107
6
Close the computer cover (see page 107).
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into
the computer.
7
Connect your computer and devices to electrical outlets, and turn them on.
8
Enter system setup (see page 113) and restore the settings you recorded in step 1.
9
Properly dispose of the old battery. See the
Product Information Guide
for battery disposal
information.
Closing the Computer Cover
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
1
Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
2
Ensure that no tools or extra parts are left inside the computer.
3
Close the cover:
a
Pivot the cover down.
b
Press down on the right side of the cover until it closes.
c
Press down on the left side of the cover until it closes.
d
Ensure that both sides of the cover are locked. If not, repeat all of step 3.
battery socket
battery
tab
To Next Page
Loading...
Need help?
General