Back to Contents Page
Camera (Optional)
Dell™Inspiron™1545ServiceManual
Removing the Camera
Replacing the Camera
Removing the Camera
1. Follow the instructions in Before You Begin.
2. Remove the display assembly (see Removing the Display Assembly).
3. Remove the display bezel (see Removing the Display Bezel).
4. Remove the display panel (see Removing the Display Panel).
5. Remove the four screws securing the brackets to the camera board.
6. Remove the camera board brackets.
7. Disconnect the camera cable from the connector on the camera board.
8. Remove the camera board.
Replacing the Camera
1. Align the camera board over the screw holes.
2. Replace the camera board brackets.
3. Replace the four screws that secure the camera board brackets to the display frame.
4. Connect the camera cable to the connector on the camera board.
5. Replace the display panel (see Replacing the Display Panel).
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™isnot
covered by your warranty.
To Next Page
Loading...
Need help?
General
